If you need to program a new key or an old key in which the battery has died, this document will guide you through the process of programming the key to your car. Follow the easy steps and in a few minutes you should have successfully programmed you key! Three methods to try: Method 1: 1. BMW e92 3 Series Comfort Access Key Fob Battery. / how to change battery / E90 key fob DIY. How to Replace BMW BATTERY without PROGRAMMING. How to program a previously used BMW keyless remote. It is the new body style E90 with. I have a 2004 BMW 530i and would like to program a new remote key. In order to access the BMW key fob battery cover you will need to remove the spare valet key from the key fob. Press down on the tab in the center of the key fob next to the key ring hole and remove the valet key. Key Fob Without Spare Key: BMW Key Fob Battery Cover Slot: Insert Flat Screwdriver: Once the key is removed from the BMW key fob you can see that there is a small slot above where. Working from within the vehicle and with the doors shut 2. Turn ignition to position 1 and back to off within 5 seconds. Remove the key from ignition and press and hold the unlock button for 15 seconds during this time press the key lock button 3 times within 5 seconds. Release both buttons. Doors will lock and unlock to show correct programming has occurred. Method 2: To do this procedure you need to have one working key and one key that needs to be programmed. 1) Get in and close all doors. 2) Turn on the ignition and turn off quickly. (No more than 5 seconds) to start the process. Next action must take place within 30 seconds. 3) Remove the 1st key. 4) Hold the key up near your left shoulder (this is so it is closer to the remote receiver antenna. 5) Hold down the unlock button and press the lock button 3 times. Release the unlock button and the doors lock which confirms the operation. 6) Quickly repeat steps 4 & 5 for key #2 etc. If it does not work, try doing the keys in opposite order. Key 2 then key 1, vs 1 then 2. Method 3: Alternate if you do not have a working remote 1. Turn key to position 1 five times very quickly 2. Remove key 3. Hold unlock button then press lock button 3 times, release unlock button. If you have another key do the same button pressing within 30 seconds 5. Turn on ignition to finalise. PLEASE NOTE: This programming procedure programs the remote control part of the key. Any transponder chip for the immobiliser (starting of car) will not be programmed and must be done by a specialist.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2019
Categories |